Gas boiler accidents are also diverse, in addition to the occurrence of coal-fired steam or hot water boiler accidents, but also may occur such as furnace and flue explosion accidents, the following Shandong Gas Boiler Factory will give you an analysis of the causes of such accidents and treatment principles, hoping to arouse everyone's attention, through the small edition of the explanation to help you!

爐膛及煙道爆炸是燃?xì)忮仩t中常見事故 。這種事故在點火或運行中都可能發生 ,尤其是在點火或維修中發生得多 。嚴重時爐墻崩塌 , 磚塊橫飛 ,爐頂和煙道掀開 ,火焰和高溫?zé)煔庀蛲鈬娚?,這時極易造成人員傷亡 。

Furnace and flue explosion are common accidents in gas-fired boilers. This kind of accident may occur in ignition or operation, especially in ignition or maintenance. When the furnace wall collapses, bricks fly across, the top of the furnace and flue are lifted, flame and high temperature smoke are sprayed outwards, which is very easy to cause casualties.

爐膛及煙道爆炸的原因：

Causes of Furnace and Flue Explosion:

(1)鍋爐點火前 , 沒有將爐膛內殘余可燃?xì)怏w排除 ,沒有點火程序控制裝置,或沒有執行操作規程 ,盲目點火所致 。

(1) Before the ignition of the boiler, the residual flammable gases in the furnace are not removed, the ignition program control device is not available, or the operation rules are not carried out, resulting in blind ignition.

(2)鍋爐運行期間突然熄火 , 沒能及時中斷燃料的供給 。

(2) During the operation of the boiler, the flameout suddenly failed to interrupt the fuel supply in time.

(3)當給油泵發生故障而使鍋爐給氣中斷時 ,未將鍋爐進氣總閥關嚴 , 當給泵恢復正常時，使大量燃?xì)膺M(jìn)入爐內。

(3) When the feeding pump fails and the feeding gas of the boiler is interrupted, the main intake valve of the boiler is not closed. When the feeding pump returns to normal, a large amount of gas enters the furnace.

(4)當電路斷電、送風機停轉 , 未立即將電源開關拉開,切斷氣源, 當送電正常后燃?xì)獯罅窟M(jìn)入爐內。

(4) When the circuit is cut off and the blower stops running, the power switch is not immediately opened and the gas source is cut off. When the power supply is normal, a large amount of gas enters the furnace.

爐膛及煙道爆炸的處理

Treatment of Furnace and Flue Explosion

(1)應立即停爐, 同時切斷電源、氣源 , 防止事故擴大。

(1) Stop the furnace immediately, cut off the power and gas sources at the same time, and prevent the accident from expanding.

(2)調節鍋爐水位至正常。

(2) Regulate the water level of the boiler to normal.

(3)對發生爐膛及煙道爆炸的鍋爐進行檢查。

(3) Inspection of boilers with furnace and flue explosion.

(4)司爐人員必須嚴格按操作規程進行操作。無論是鍋爐啟動前的次點火,還是鍋爐運行中熄火后的再次點火,必須按點火操作程序進行 。

(4) Furnace supervisors must strictly follow the operating rules. Whether it is the first ignition before the start-up of the boiler or the second ignition after quenching in the operation of the boiler, it must be carried out according to the ignition operation procedure.

本章由山東燃?xì)忮仩t廠家給大家介紹的內容就暫且到這里，希望我們的解答能夠幫助到您，如果您對此還有疑問，詳情請咨詢我們的官方。http://m.tiaoi.com.cn

This chapter is introduced to you by Shandong Gas Boiler Manufacturer. I hope our answers can help you. If you have any questions about this, please consult our official for details. Http://m.tiaoi.com.cn