1. When the stainless steel filter has not been used for a long time, we must discharge the filtrate inside the filter, and then take out the filter element for cleaning and drying process. After completing this series of operations, put the product into a clean plastic bag and seal it to ensure that the filter element product is not polluted. Finally, clean the stainless steel filter and store it in a dry place

2.一般,換下來的濾芯要浸泡于酸性強度強的洗液中,浸泡時長約為24小時左右,切記,酸性液體的溫度要保持于25-50度左右,在進行浸泡的過程中時,我們建議酸與堿占液體的比例要控制在20%之間,這是為了避免液體對濾芯產品內部的破壞與污染.

2. Generally, the replaced filter element should be immersed in strong acid detergent for about 24 hours. Remember that the temperature of acid liquid should be kept at about 25-50 degrees. In the process of soaking, we suggest that the ratio of acid and alkali to liquid should be controlled between 20%, which is to avoid the damage and pollution of the liquid to the filter element

3.一般而言,蛋白因子較高的洗液產品好,不管是從清潔度上還是節約上而言,效果都很好.因此,應當利用蛋白含量較高的酶溶液進行清洗.當清理過后,一定要進行二次清洗,并采用蒸汽進行整體,這流程對過濾器的保養更為重要.

3. Generally speaking, the lotion product with higher protein factor is good, and the effect is very good both in terms of cleanliness and economy. Therefore, the enzyme solution with higher protein content should be used for cleaning. After cleaning, it is necessary to carry out secondary cleaning and use steam for overall disinfection, which is the most important process for the maintenance of the filter

4.不銹鋼過濾器在過程中要注意一定的時間和溫度,通常,內部的濾芯產品要在柜中放置130℃/20分鐘,溫度不宜超過150℃,更長時間不能超過30分鐘.要切記,一旦溫度過高,抑或時間長、壓力大,都會導致過濾器內部元件(濾芯)的整體損壞.

4. The stainless steel filter should pay attention to a certain time and temperature in the disinfection process. Generally, the internal filter element products should be placed in the disinfection cabinet at 130 ℃ / 20 minutes, the disinfection temperature should not exceed 150 ℃, and the longest disinfection time should not exceed 30 minutes. It should be remembered that once the disinfection temperature is too high, or the time is long, and the pressure is high, the internal components (filter element) of the filter will be damaged as a whole