鍋爐循環清洗系統應符合要求
　　Boiler circulating cleaning system shall meet the requirements
　　(1)清洗槽應具有足夠的容積和強度;
　　(1) the cleaning tank shall have sufficient volume and strength;
　　(2)用耐腐蝕泵對泵進行清洗，并滿足循環清洗所需的流量和揚程。同時現場提供備用泵;
　　(2) use corrosion-resistant pump to clean the pump, and meet the flow and head required for circulating cleaning. Meanwhile, standby pump shall be provided on site;
　　(3)過濾器進口應安裝在清洗泵進口或清洗水箱出口。網孔直徑應小于5毫米，并有足夠的流道截面;
　　(3) the filter inlet shall be installed at the inlet of the cleaning pump or the outlet of the cleaning water tank. The mesh diameter shall be less than 5mm, and there shall be enough flow passage section;
　　(4)清洗系統各管道應具有足夠的流動截面面積，以保證清洗液的流速。同時，各回路的流量應均勻，避免回路之間短路;
　　(4) each pipeline of the cleaning system shall have sufficient flow cross-section area to ensure the flow rate of the cleaning solution. At the same time, the flow of each circuit shall be uniform to avoid short circuit between circuits;
　　(5)在鍋爐頂部和封閉的清洗罐頂部安裝通向場所的排氣管。排氣管應有足夠的流通面積;
　　(5) install the exhaust pipe leading to the safe place on the top of the boiler and the closed cleaning tank. The exhaust pipe shall have sufficient flow area;
　　(6)清洗系統閥門應靈活、嚴密，無銅質部件。過熱器應注入適當?shù)谋Ｗo(hù)液。未涉及清洗的系統、設備等應可靠隔離或保護;
　　(6) valves of cleaning system shall be flexible and tight without copper parts. The superheater shall be filled with appropriate protective fluid. Systems and equipment not involved in cleaning shall be reliably isolated or protected;

　　(7)清洗液配制及加熱裝置應操作方便、可靠。
　　(7) the preparation of cleaning solution and heating device shall be easy to operate, safe and reliable.
　　很多時候，當我們安裝和使用鍋爐的時候，我們會發現鍋爐的水量并沒有達到我們的預期。如果我們更換鍋爐，會造成經濟損失，所以我們需要增加鍋爐的水量。
　　Many times, when we install and use the boiler, we will find that the water volume of the boiler does not meet our expectations. If we replace the boiler, it will cause economic loss, so we need to increase the water quantity of the boiler.
　　盡量選用熱值較高的煤，盡量選用幾種煤;提高鍋爐入口溫度，保持入口管道良好;你可以適當增加鍋爐的風量。你可以換一個大點的風扇。這樣可以增加鍋爐受熱面的通風，增加鍋爐的吸熱;
　　Try to select coal with higher calorific value and several kinds of coal; increase the boiler inlet temperature and keep the inlet pipeline in good condition; you can increase the air volume of the boiler appropriately. You can change a bigger fan. In this way, the ventilation of the heating surface of the boiler can be increased and the heat absorption of the boiler can be increased.
　　在鍋爐中使用一段時間后，水垢和灰塵也會影響自身的出水，所以需要及時清理。
　　After using in the boiler for a period of time, scale and dust will also affect its own water, so it needs to be cleaned in time.