In view of the special radiation protection function of the radiation protection door, pay attention to the following small installation skills during the specific construction:

1、把做好的射線防護門放入到門洞內(必要時把門扇拆下),使射線防護門包邊內面與接觸面貼合墻體并垂直,必要時糾正墻體表平面。

1. Put the radiation protection door into the door opening (remove the door leaf if necessary), make the inner surface of the edge of the radiation protection door and the contact surface fit the wall and vertical, and correct the surface of the wall if necessary.

2、對射線防護門側框體進行垂直定位,必須做到點面在同一平面上.

2. For the vertical positioning of the side frame of the radiation protection door, the point plane must be on the same plane

3、對射線防護門的鉸位側框體進行固位,拉爆、固位或拉片固位,必需安裝牢固。

3. The hinged side frame of the radiation protection door shall be fixed, blasted, fixed or clamped firmly.

4、調整鎖位寬體垂直位置,使門扇同門框之間的間隙位置達到均勻一致,并做更終的固定。

4. Adjust the vertical position of the lock position wide body to make the gap between the door leaf and the door frame uniform and make the final fixation.

5、待水泥漿或發泡膠干燥后,取下間隙片及其墊板即可。

5. After the cement slurry or styrofoam is dried, remove the clearance piece and its base plate.

6、更要要注意檢查所需安裝的射線防護門,檢查及其開關是否靈活順暢，確定門開關順暢后，再用鉛板或者硫酸鋇防護涂料將門口墻面及門墻縫隙處理密封，保證射線不外泄就OK了。

6. The most important thing is to check the ray protection door that needs to be installed, check whether its switch is flexible and smooth. After confirming that the door switch is smooth, use lead plate or barium sulfate protective coating to seal the door wall and the door wall gap, so as to ensure that the ray does not leak.

本文由射線防護器材友情奉獻.更多有關的知識請點擊:http://m.tiaoi.com.cn 真誠的態度.為您提供為全面的服務.更多有關的知識我們將會陸續向大家奉獻.敬請期待.

This article is dedicated to radiation protection equipment. For more information, please click: http://m.tiaoi.com.cn  Sincere attitude. For you to provide a comprehensive service. More relevant knowledge we will continue to dedicate to you. Please look forward to