有什么方法可以提高山東燃氣鍋爐的燃燒效率?
　　What method can improve the combustion efficiency of gas boiler?
　　鍋爐產生大量的還原性氣氛和散發(fā)熱加載作用下的強烈擾動之間的高溫煙氣爐的爐篦空氣和二次空氣,強干擾的高溫煙氣爐的擴散爐篦空氣。下面小編就來告訴大家形成油氣鍋爐燃燒的條件如下:
　　The boiler produces a lot of grate air and secondary air of high-temperature flue gas furnace between reducing atmosphere and strong disturbance under the action of scattered heating load, and the diffusion grate air of high-temperature flue gas furnace with strong disturbance. Here is a brief introduction to the conditions for the combustion of oil and gas boilers:
　　1. 爐排孔不明顯，傾角合理，停止間隔、振動頻率和振動時間適宜。
　　1. The grate hole is not obvious, the inclination angle is reasonable, and the stop interval, vibration frequency and vibration time are appropriate.
　　2、先吹過燃料的風，火的底部風是豐富的，微微沸騰。
　　2. The wind that blows through the fuel first, the wind at the bottom of the fire is rich and slightly boiling.
　　3、二次風角合理，且能抑制管柱上的火焰。
　　3. The secondary air angle is reasonable and can restrain the flame on the string.
　　4. 適宜的氧含量為3% ~ 6%，秸稈燃料含碳量低，揮發(fā)分含量大，灰分含量大，燃料空隙率大，燃盡時間長，需要富氧燃燒。
　　4. The appropriate oxygen content is 3% - 6%. Straw fuel has low carbon content, high volatile content, high ash content, large fuel voidage, long burn out time and needs oxygen enriched combustion.
　　5、根據燃料干燥程度，利用點火風，盡量提高燃料預熱溫度，形成爐排火災。
　　5. According to the drying degree of the fuel, the ignition air is used to increase the preheating temperature of the fuel as much as possible to form a grate fire.

　　6. 保持燃料濕度低于20%，降低點火溫度。
　　6. Keep the fuel humidity below 20% and reduce the ignition temperature.
　　7. 將燃油灰分保持在20%以下，以增加燃盡的程度。
　　7. Keep fuel ash below 20% to increase burnout.
　　8. 爐排兩側燃料分布為中、高、低，爐排厚度適宜。
　　8. The fuel distribution on both sides of the grate is medium, high and low, and the thickness of the grate is appropriate.
　　9. 燃料應盡可能的細，顆粒大小應適合與氧保持良好的結合表面。
　　9. The fuel shall be as fine as possible and the particle size shall be suitable for a good bonding surface with oxygen.
　　10. 連續(xù)喂料，避免分段喂料。
　　10. Continuous feeding, avoid sectional feeding.
　　11、一次風和二次風的比例是3:7或4:6，根據不同的材料來選擇風的速度，使風的速度適合燃料的燃燒。
　　11. The ratio of primary air and secondary air is 3:7 or 4:6. Select the speed of wind according to different materials, so that the speed of wind is suitable for fuel combustion.
　　12. 二次風及時進入爐膛，攪拌爐膛內氣體混合，使爐膛內煙氣產生渦流，增加了爐內懸浮的粉煤灰和粉煤灰可燃物的行程，進一步減少了粉煤灰和粉煤灰可燃物。
　　12. The secondary air enters the furnace in time, mixing the gas in the furnace, making the flue gas in the furnace generate eddy current, increasing the travel of the suspended fly ash and fly ash combustibles in the furnace, and further reducing the fly ash and fly ash combustibles.